![]() Repeat this step for the external vEthernet and the other Ethernet interface. Set-VMNetworkAdapterVlan -ManagementOS -VMNetworkAdapterName "ExternalSwitch" -Access -VlanID ![]() Set the Hyper-V host to use the correct VLAN. Run the following commands to tag the external network.Ĭheck the current settings. set-VMSwitch -SwitchName ExternalSwitch -NetAdapterName NetAdapterTeam The represents an array.Ĭonnect the team to the ExternalSwitch. Replace X and Y with the numbers you obtained from the previous command. new-NetLBFOTeam -Name NetAdapterTeam -TeamMembers X”, “Ethernet Y”) Run the following commands to recreate the NIC team. get-NetAdapterAdvancedProperty -DisplayName “Jumbo Packet” | format-table Name, RegistryValue set-NetAdapterAdvancedProperty -Name “Ethernet X” -DisplayName “Jumbo Packet” -RegistryValue 9014 Run the following commands to check and set the jumbo frames. get-scvirtualmachineįor System Center, all the commands are in the -sc format. get-winevent -providername ixgbn get-winevent -providername I*network* Network Troubleshooting Commands get-netadapterstatus netsh interface ipv4 show ipstats netsh interface ipv4 show tcpstats Netadapter Team Commands get-netlbfoteam get-netlbfoteammember new-netlbfoteam add-netlbfoteammember Remove-NetLbfoTeamMember Network Adapter Commands get-netadapter get-vmnetworkadapter -managementOS get-vmnetworkadapter get-vmswitch add-vmnetworkadapter -managementOS set-vmnetworkadaptervlan get-netadapteradvancedproperty connect-vmnetworkadapter disconnect-vmnetworkadapter disable-VmNetworkAdapter If you accidentally close all the CMD windows, press ctrl+alt+del and go to the task manager to open a new CMD window.įollowing is a list of some useful Hyper-V commands. If you are in Windows PowerShell, your prompt string starts with PS. In a CMD window, type powershell to access Windows PowerShell. Use the Get-help command to access the man pages. This makes it easy to figure out the flags. The tab-completion tool not just completes commands, but also looks through all possible completions. You can also use the Tab key to complete the commands. Remember this structure and you can use most of the Hyper-V commands. This structure of the Hyper-V commands works anywhere in Windows PowerShell. To set something on the network adapter, type: set-netadapter To list all the network adapters, type: get-netadapter ![]() If yes, you can access the data that you are looking for using the link provided below.įor those who do not have access to Nutanix KB’s, I’m pasting few useful powershell commands for Hyper-V network management. Hi - I assume that you have access to Nutanix knowledge base.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |